Triad's New Plate Marking Saw is designed for the utmost efficiency and accuracy, built from quality materials and brought to you from undisputed leader in wall panel equipment with over 45 years experience.

Like all Triad equipment, the Plate Marking Saw has been designed, programmed, and built by the same people you have known and trusted over the last FIVE DECADES with your component equipment needs!

FEATURES:

HARDWARE - 10hp, 3 phase saw motor, 18" - 60 tooth carbide saw blade. Dual V-belt drive for quiet operation. Pneumatic materials clamps and hold downs. Twin cyclical feed pusher (no time wasted for retracting). Three convenient start & stop locations along the frame. Heavy-duty steel construction, leveling feet, painted Triad Tan.

CUTTING - Cuts 2" x 4" to 2" x 8" plates at 90 degrees or miters them up to + 45 degrees. Cuts one board at a time to accommodate top & bottom plates of different lengths.

CONTROLS - Servo controlled feed and blade angle. Touch screen control console, industrial rated programmable controller. Connects to existing Ethernet network with fixed IP address or PC to PC. Uploads Triad .tcs wall panel files created by Triad "Saw Talk" software (see below).

MARKING - Low maintenance, high-speed percussion marking system. Two case hardened marking emblems. Maximum feed velocity of 290 fpm.

TRIAD SAW TALK SOFTWARE SPECIFICATIONS:

Runs on any standard PC using Windows 2000, XP or Vista operating systems with Ethernet capabilities (customer supplied)

Imports from several common house design software packages

Allows combining, splitting and omitting of components

Supports JIT optimization

3-D board visualization, including marking detail (see what you're cutting before you actually cut it)

Allows the saving of jobs in standard Triad .tcs file format for easy recall and storage

Downloads files to Triad Plate Marking Saw (see above)

*All specifications are subject to change without notice*