The Triad Floor
Panel System was designed to be used as a
combination floor framing bridge and a decking
nailing/staple bridge. The Floor
Panel System is used on the
Triad Generation II Framing Table
as a single table floor panel manufacturing system.
Bridge specifications are as follows:
BRIDGE SPECIFICATIONS:
-
Bridge widths: 12' 2" or 14' 2".
-
Standard Hand Crank Control for bridge movement.
-
Push Button Controls located on Bridge control panel.
-
Optional Joystick Control for bridge drive, tool firing and tool
shift. Auto Return option included with Joystick
Control.
-
Optional Automatic Bridge Return.
-
Optional Laser Pointer for positioning the Bridge at stud and
component locations.
FRAMING
SPECIFICATIONS:
-
Three pneumatic nailing tools on each side of the bridge for
framing 2" x 8", 2" x 10", and 2" x 12" joists.
Four nails are fired in 2" x 8" floors, five nails
are fired in 2" x 10" floors, and six nails are
fired in 2" x 12" floors.
-
Down clamping pads are designed to clamp and flush the joists to
the rims. Clamping pressure is 314 lbs. and
activates simultaneously with tool firing
activation.
-
Clamp senses 2" x 8", 2" x 10" and 2" x 12" joists for automatic
setting of nail pattern.
OPERATIONAL FEATURES:
After the floor panel has been laid out and clamped and
squared in the Gen II Framing Tables, one operator guides the
Floor Panel System along the Framing Table using either the Hand Crank Control or the
optional Joystick Control. At each joist and component
the operator lines up the center control box or with the
optional Joystick Control each joist and component is
fastened to both rims. Flushing the joist to rims is
automatic, as the tools are activated to fire, a down
clamp automatically and simultaneously flushes the rims
to the joists.
After the decking has been placed on the panel and
tacked in each corner all openings are routed out with
two operators using the
Triad Handle Bar Router
or
one operator using the
Triad Router Bridge.
One operator guides the
Floor Panel System along the Framing Table using either the Hand Crank Control or the
optional Joystick Control. At each joist and component
the operator locates the firing position either visually
or with the assistance of the optional laser pointer.
At each firing position the operator activates the
pneumatic tools by either depressing the Fire/Shift
button on the control panel or by engaging the Joystick
Control. With the optional Space Fire feature, the
bridge will automatically fasten both rims as the bridge
traverses along the panel. The Perimeter Fire feature
provides pneumatic nailing/stapling around all openings
using the Joystick Control. Upon completion, the
operator either manually or with the Automatic Bridge
Return feature, returns the bridge to its starting
position and rolls the floor panel to the next station
where the panel is removed from the production line.
*All
specifications are subject to change without notice*
