Stud Locating Flipper
Cast iron stud locating flippers are an exclusive of
Triad. The flippers are
counterbalanced into the upright position. When need be,
they lay down out of the way. Stud locators can be 12", 16"
or 24" on center and be color coded. The locator brackets
are slotted in order to assure exact center placement during
table setup.
Touch control
The latest state of the art in operator controls for
raising and lowering the roller conveyor and for activating
the power width adjust for wall height changes as well as
power clamping the walls prior to nailing. The operator
simply touches the ribbon control to activate it from any
position along the table's length. Saves operator steps and
time.
Standard Controls
A drum
switch is used to activate the standard electric power width
adjust from 6'9" to 9'3" and to clamp the wall square prior
to nailing. A throw switch is used to raise and lower the
roller conveyor.
Tool Dolly Rails
The tool dollies ride on solid steel rails. This solid rail
system is bolted to the main framework of tubular steel for
engineered strength. Two bolts are used in order to allow
for precise adjustment of the rail for lining up the tool
dollies. The nycoil air line for the tool carriage also
attaches to the down rigger to keep the air line off of the
floor.
Roller Conveyor
The roller conveyor is nested below the working surface to
protect the rollers. When activated, the rollers rise up
raising the framed wall out of the stud locators for removal
of the end of the table. A solid squaring lip is provided
the full length of the table for squaring the walls.
Pop Up Rollers
The rollers are activated up and down by air cylinder from
the under side of the table. The air exiting from these
cylinders is muffled to enhance
Triad's quiet quality. You will also note the air
cylinder uses a tubular guide body to assure the cylinder's
long life and lasting quality, eliminating the stress of the
cylinder itself.
Power Width Adjust
Rack and pinion gears are used in conjunction with an
electric motor with brake, gear box and torque limiter for a
positive clamping action for squaring walls prior to
nailing. Table width adjust can be activated by a drum
switch or touch control ribbon by custom order.
SPECIFICATIONS:
- Height
28" from floor
- Width
6'9" to 9'3", 6'9" TO 10'3", 6'9" TO 12'3"
- Working
length 16', 20' 24' (Additional lengths optional)
- Actual
length 1'6" longer than working length
- Shipping
weight Approx. 2,000 pounds for 20' table
- Air
required ½ NPT 10 CFM @ 90 PSI
- Electric
Power 110V, 1PH
*All
specifications are subject to change without notice*
|
