RUVO
9808A Hinge / Strike Jamb &
Mortising Machine
|
The new RUVO 9808A Hinge and Strike Jamb
Mortising Machine is to be used in conjunction
with the machining and preperation for steel
door assembly or whenever a special machine is
required for processing jambs only. The Ruvo
9808A will mortise for two, three, or four
hinges and will cut for the strike hole and
rectangular faceplate. It is adjustable for
length and width of jambs, location and number
of hinges, size of hinges, size of strike hold
and faceplate.
The Ruvo 9808A will work on split or flat jambs with or without applied stops. The hinge jamb is clamped in place, the first hinge is routed and the machine automatically advances the hinge jamb to the next preset hinge location. While this is taking place, the machine operator places the strike jamb against the left or right hand stops, and manually follows a designated template cutting the strike hole and faceplate. The strike plate template is easy to remove and replace for various size and shape plates. SPECIFICATIONS: (subject to change without notice) Electrical: 110/115 V - 21 Amps Single phase - 60 HZ Air: .1 cfm. at 90 PSI at machine with ½" feeder air line. Jamb sizes 6'6" to 8'0" long - 4 9/16" to 10" wide Strike sizes 2 ¼" to 2 ¾" (1/4" in radius) Hinge sizes 3 ½ ", 4", 4½" (5/8" radius) *All specifications are subject to change without notice* |
